This time, I made a cross front bubble hem version of McCall’s 6992. The pattern is a simple raglan sleeve pullover, with long cuffed sleeves. I started with the basic pattern, back, front and sleeve. I chose a black and white sweater knit from Fabric Mart, and scraps of black jersey from the stash for the binding and cuffs.
I used the serger for most of the construction steps, including sewing the cuffs, sewing the construction seams, and attaching the cuffs.
I cut the neckline ridiculously high and small, because I planned to cut it down to the correct size later. I cut two front pieces. I placed them so that one piece was right side up, then I placed the other piece on top of it, also right side up, lining up all the cut edges. Then, I sewed across the bottom hem. I flipped the lower piece around, so it became the top piece. Both pieces were right side up. The seam allowance of the hem seam was hidden inside the bubbly- poof at the bottom of the front.
I sewed the raglan sleeves to the back piece. Then on the right side of the top, I sewed both front pieces to the raglan sleeve. I sewed both front pieces to the back at the side seam, and sewed the under arm seam. On the left side, I sewed only the lower front piece to the raglan sleeve, and the under arm seam. I pinned both front pieces to the back piece along the seam, but did not sew it.
I popped the top on, marked where I wanted the neckline to be, took the top off, and cut the neckline. I put the top back on, and using straight pins, marked along the line I wanted to follow when cutting the upper layer of the top away.
I took off the top and laid it flat on my cutting mat. I unpinned the left side, and smoothed out the layers. I took a deep breath, picked up my scissors, and cut away the top layer, more or less following the line of straight pins.
End result – the cutaway front adds interest to this simple pullover sweater. It was an easy pattern hack.